多槽超聲波清洗機是一種特殊的清洗機，這類清洗機傳出超音波，讓超音波在溶液中散播，使液態與清洗槽在超聲工作頻率下一起震動，促使清洗實際效果大大的提高。液態與清洗槽振蕩時會自身共振頻率，這類振動頻率是聲音頻率，因此我們會聽見嗡嗡響。伴隨著清洗領域的飛速發展，越來越多領域和公司開始使用超聲波清洗機。
Multi tank ultrasonic cleaning machine is a special kind of cleaning machine. This kind of cleaning machine sends out ultrasonic wave, which makes the ultrasonic wave spread in the solution, making the liquid and cleaning tank vibrate together at the ultrasonic working frequency, thus greatly improving the actual cleaning effect. When the liquid oscillates with the cleaning tank, it will have its own resonant frequency. This kind of vibration frequency is the sound frequency, so we will hear the buzzing. With the rapid development of cleaning field, more and more fields and companies begin to use ultrasonic cleaning machines.
多槽超聲波清洗機的特點是超音波清洗效果明顯，使用方便。大家所聽見的聲音是工作頻率20~20000Hz的聲波頻率數據信號，高過20000Hz的聲波頻率稱作超音波，聲波頻率的傳送按照正弦曲線豎向散播，造成很多氣泡。造成汽泡的原因是液態內部分發生拉應力而產生負壓力，氣體壓強的減少使原先溶解于液態的汽體過于飽和，而從液態逸出，變成氣泡;另一原因是強勁的拉應力把液態“撕掉”成一裂縫，稱之為空化。
The ultrasonic cleaning machine with multiple grooves is characterized by obvious ultrasonic cleaning effect and convenient use. The sound you hear is the acoustic frequency data signal with a working frequency of 20~20,000 Hz. The acoustic frequency higher than 20,000 Hz is called ultrasonic wave. The transmission of acoustic frequency is vertically scattered along a sinusoidal curve, causing many bubbles. The reason for the bubble is that the tensile stress in the liquid generates negative pressure, and the reduction of gas pressure makes the vapor dissolved in the liquid supersaturated, and escapes from the liquid to become a bubble; Another reason is that the strong tensile stress "tears" the liquid into a crack, which is called cavitation.

1、將需要清洗的商品放進清洗機的清洗籃中，隨后將清洗籃放進清洗槽，不能將商品立即放進清洗槽里，防止破壞機器設備及清洗實際效果。依據不一樣的商品或是清洗實際效果，按比例倒進清洗液，水位線少不可少于60mm，而大不能超過80mm。
1. Put the goods to be cleaned into the cleaning basket of the washing machine, and then put the cleaning basket into the cleaning tank. Do not put the goods into the cleaning tank immediately to prevent damage to the machine equipment and the actual cleaning effect. According to different commodities or the actual cleaning effect, pour the cleaning solution in proportion, with the water level no less than 60mm and no more than 80mm.
2、接通電源，開啟多槽超聲波清洗機按鍵開關，電源開關亮表明正常工作。根據物件的清洗規定，開啟多槽超聲波清洗機溫度操縱開展溫度調整。溫度顯示燈滅掉電加熱器做到所需的標準，電加熱器會停止工作，若小于設定的溫度，電加熱器往往會再次全自動加溫。當加溫溫度做到商品清洗規定時，能夠打開清洗計時器，依據商品清洗規定設定計時器的上班時間。
2. Turn on the power, turn on the key switch of the multi slot ultrasonic cleaning machine, and the power switch is on, indicating normal operation. According to the cleaning regulations of objects, open the temperature control of the multi tank ultrasonic cleaner to adjust the temperature. The electric heater will stop working when the temperature indicator light is off and the electric heater meets the required standard. If the temperature is lower than the set temperature, the electric heater will often be fully heated again. When the heating temperature meets the commodity cleaning regulations, the cleaning timer can be turned on, and the working time of the timer can be set according to the commodity cleaning regulations.
3、清洗結束后，在清洗槽取下清洗籃，用溫開水清洗或是在另外一個并沒有有機溶劑的溫開水清洗槽里浸洗。物件清洗完要開展干躁、儲放拼裝。
3. After cleaning, take down the cleaning basket in the cleaning tank and wash it with warm water or soak it in another warm water cleaning tank with no organic solvent. After cleaning, the articles shall be dried, stored and assembled.
本文來自：多槽手動超聲波清洗機更多的內容請點擊：我們將會為您提問的問題提供一個滿意的服務，歡迎您的來電！
This article is from: Multi slot manual ultrasonic cleaner For more information, please click: We will provide a satisfactory service for your questions. Welcome to call!